Google Translate

Categories

FPV 5.8G TX RX Full Set Carbon Fiber Mini QAV250 C250 Quadcopter T6 transmitter

FPV 5.8G TX RX Full Set Carbon Fiber Mini QAV250 C250 Quadcopter T6 transmitter

Product Code: 6124
Reward Points: 0
Availability: In Stock
Price: £197.86

Carbon Fiber Mini 250 FPV Quadcopter Frame Specifications:
- Materials: 3k Weave Carbon Fiber
- Fasteners: Stainless Steel & Black Nylon 6/6
- Size: 220mm diagonally, 175mm wide, 130mm long motor-to-motor; about 1/2 the size of a regular quadcopter
- Maximum Propeller: 5"
- Motor Mount: M2 12mm - 16mm (Tiger MN1806 2300kv, RCX 1804 2400kv), M3 19mm (Tiger MT2206 2000kv, Sunnysky X2204 2300kv)
- Flight Controller Mount: 30.5mm x 30.5mm
- Board Camera Mount: 32mm x 32mm


Flysky FS-T6-RB6 2.4GHz Specifications:
- Channels: 6 Channels
- Type:  Mode 2
- RF Range: 2.40-2.48GHz
- Bandwidth: 500Hz
- Band: 160
- RF Power: Less Than 20dBm
- 2.4GHz System: AFHDS
- Code Type: GFSK
- Sensitivity: 1024
- Low Voltage Warning: 9V
- DSC Port: PS2; Output: PPM
- Charger Port: Yes
- Power: 12V DC (1.5AA*8)
- Weight: 590g
- ANT Length: 26mm
- Size: 302x190x93mm
- Certificate: CE, FCC

Required to Operate:
- 8 AA Batteries for Transmitter


Mystery A2208 1800kv Brushless Motor Specification:

- No:  A2208
- RPM/V:   1800KV
- No. Of cells(Ni-MH):   6-8
- No. Of cells(Li-Po):   2-3
- Max. efficiency current: 6 - 10 A (>74%)
- NoLoad current/10 V:    0.8 A
- Current capacity:    16A/60 s
- Max. efficiency:     0.78
- Shaft diameter (mm):     3 mm
- Weight with cables: 36 g
- Internal Resistance: 90 mΩ
- Dimensions(mm):   27.5x26

SimonK 12A Brushless ESC Speed Controller
Features:
- Based on Simon K firmware, further optimized to the perfect drive performance.
- Low-voltage protection, over-heat protection and self-check functions.
- Separate power supply for MCU and BEC, enhancing the ESC’s ability of eliminating magnetic interference.
- Parameters of the ESC can be set via program card or transmitter.
- Throttle range can be set to be compatible with different receivers.
- Equipped with built-in linear BEC or switch BEC.
- Max speed: 210,000 rpm for 2-pole, 70,000 rpm for 6-pole, 35,000 rpm for 12-pole.

Specifications:
- Continuous Current: 12A
- Burst current (10S): 16A
- Li-xx Battery (cell): 2-4Cell
- Dimension (L*W*H): 21mm x 22mm x 4mm
- Weight wires Included: 12g
- BEC Mode: Linear
- BEC Output: 1A/5V
- Programmable: Yes

CC3D Flight Controller Introduction:
OpenPilot is a next-generation Open Source UAV autopilot. It is a highly capable platform for multi-rotor craft, helicopters, as well as fixed wing aircraft. It has been designed from the ground up by a community of passionate developers from around the globe, with its core design principals being quality, safety, and ease of use.  Simplicity does not come with any compromises either: with no hard-coded settings, a complete flight plan scripting language and other powerful features, OpenPilot is an extremely capable UAV autopilot platform.

FPV TS5823 5.8G 200MW 32CH Transmitter Specification:
- Transmitter unit weight: 7.3g (excluding antenna)
- Video format supported: NTSC / PAL
- Working frequency: 5645-5945Mhz
- Power input: 7-24V
- Transmitting current: 190mA @ 12V
- Video bandwidth: 8M
- Audio coding: 6.5M
- Dimension: 30 * 20 * 8mm (excluding antenna)
- Antenna connection: RP-SMA jack (TX module side)
- Frequency range 
 


FPV RC832 5.8G Receiver Specification:
- Video format supported: NTSC/PAL
- Antenna connection: RP-SMA, jack (module side)
- Sensitivity:≤-90dBm
- Power input: 12V
- Working current: 200mA max
- Antenna impedance: 50ω
- Antenna gain: 2db
- Video impedance: 75ω
- Video format: NTSC/PAL auto
- Dimension: 80x 65 x15mm
- Weight: 85g

 

5.8G Clover-Leaf Circular Polarized Antenna Specifications:
- Gain: 5dBi
- Antenna connector: SMA plug (the connector on the antenna side is referred to, please disregard the label on the antenna if there is discrepancy)
- Standing wave ratio(SWR): <1.5
- Length: 8cm (TX)/10cm(RX)
- Weight: 12.5g(TX)/14g(RX)


700TVL Mini CCD Camera Specifications:
- Sensor : CCD Sensor
- Product name: 700 TVL
- Size::  38mm*38mm
- Pixel: PAL:1020Hx596V      NTSC: 1020Hx508V
- Effective picel: PAL:  976Hx582V   NTSC: 976Hx494V
- Signal format:   PAL/NTSC (N CCD is672)
- Resolution:700TVL
- Digital noise reduction:2DNR,support 0-16 grade adjustment
- OSD Menu:Support
- Min lumen: 0.01LUX/F1.2
- SNR: <=48dB
- Video out put:1.0Vp-p/75ohm
- AGC (automatic gain control) :0.25/0.50/0.75/1.00 adjustable,max up to 55db
- White balance method:open/close
- HLC High light compensation
- Elsctronic Shutter:  1/50(1/60) - 1/100000 second
- Gamma correction:  0.45/1.0
- Lens: 3.6MM Glass lens
- Voltage: DC12V+-5%
- Working current: 70MA
- Working temperature: -20℃--60℃


7 inch HD LCD TFT Screen Monitor Specifications:
-  Screen size: 7" inch  
-  Display format: 16:9  
-  System: PAL/ NTSC (Auto switch)  
-  Resolution: 800 x 480  
-  Brightness: 350cd/m2  
-  Contrast: 350:1  
-  Red line:  Power Input   
-  Yellow and White line: vedio  input  
-  Housing Material: ABS
-  Low power consumption  
-  Power Supply: DC 12V  
-  Operating Temperature 0°C ~+ 80°C  
-  Storage Temperature -10°C + 80°C  
-  Dimensions: 174 x 113 x 19 mm


Package:
- Mini 250 FPV Quadcopter Frame x1
- ESC Connection Board x1
- Mystery A2208 1800kv Brushless Motor x4
- 12A Simonk ESC x4
- 5030 Propeller CW&CCW x4
- 700TVL Mini CCD Camera x1
- CC3D Openpilot Open Source Flight Controller
- 5.8ghz Antenna(TX & RX) x1
- TS5823 5.8G 200MW 32CH Transmitter x1
- FPV RC832 5.8G Receiver x1
- 7 inch HD LCD TFT Screen Monitor x1
- Flysky FS-T6-RB6 2.4GHz Transmitter & Receiver x1

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: